for bathrooms, kitchens, for balconies
Sticking the tiles after 2 hours for moisture insulation
sticking tiles on the floors after 4 hours
Wall consumption approx. 1 kg/m², consumption on the floor approx. 2.0 kg/m²
highly flexible, with high adhesion
Introduction of a set of products for waterproofing insulation
Atlas Woder E is intended for waterproofing wet rooms (bathrooms, shower cabins, etc.) and balconies.
ATLAS WODER E is a modern material, whose recipe consists only of the highest quality hydrogenous copolimer dispersion along with properly selected fillers and additives. Meticulously selected proportions ensure optimal parameters of the ready coating, creating a waterproof and non -leafless material called commonly quick -drying liquid foil. The use of it together with additional products in the form of sealing tapes and special collars allows obtaining a 100 % tight coating even on complex surfaces.
Main properties
Atlas Woder E is produced in a form ready for use of polymer dispersion, fillers and modifying agents
Fast drying - the ability to apply another layer after 1 hour, and making ceramic cladding after:
- 2 hours for waterproof insulation (e.g. walls in bathrooms and kitchens)
- 4 hours for moisture insulation (e.g. floors in bathrooms and kitchens, balconies)
is highly elastic - it can be used on substrates made in underfloor and wall heating systems and on other surfaces subject to deformations
It is resistant to the formation of scratches in the ground - thanks to special polymers, the mass bridge is up to 0.8 mm wide, which means that the waterproofing will remain tight even when the ground underneath is outlined
It has high adhesion to typical building substrates - e.g. for concrete about 2.2 MPa
frost resistance-does not lose its properties even in the case of multiple transition of the freezing cycle
resistant to UV, frost and aging
is a coating seal - it creates a thin coating (it must be protected against mechanical damage, e.g. as a result of pedestrian movement or impact - it is necessary to make, for example, tile cladding)
It can be used directly under the tiles - it replaces roofing felt and traditional films, where the floor underfloor was required before sticking the tiles
Seamless material - the type of material allows you to get a continuous coating, without the need to create plants and special connections, as is the case with agricultural materials
Application in a wide temperature range - the possibility of applying material at the ground and the environment from 5 to 30 ° C
convenient and easy to apply - insulation in the form of dispersion before use requires only mixing the content of the packaging; It is easily applied to both G-K, OSB plates, as well as cement or gypsum plasters, metal and PVC elements
It enables gradual consumption in 12 months - despite the opening of the bucket and partial use, it gives the possibility of applying the remaining part throughout the entire shelf life, i.e. 12 months from the date of production
It allows you to easily control the thickness of the applied layer - both when applying with a brush, roller and steel trowel
It binds virtually unspeakless - linear contraction is kept to a minimum - during drying, no cement mortars appear and cramps characteristic of cement mortars and cramps
Main parameters
High adhesion - for typical concrete substrates 2.2 MPa
Making a second layer after 1 hour
Playing tiles:
- after about 2 hours (for moisture insulation)
- after approx. 4 hours (for waterproofing)
WEAR
The consumption depends on the conditions of water impact (see technical data):
- moisture insulation: 1.0 kg /m²,
- waterproof insulation: approx. 2.0 kg/ m².